Skip to main contentSkip to main content
You have permission to edit this article.
Edit
Alfalfa rotation boosts corn yield in study

Alfalfa rotation boosts corn yield in study

  • Updated
Alfalfa close up

Editor’s note: The following was written by Jeff Coulter, University of Minnesota, for the university’s Minnesota Crop News website.

Alfalfa provides many benefits to the corn crops that follow it, with the most notable being greater yield and reduced need for nitrogen application compared to when it is grown in other rotations.

Across 15 years at one location in southwestern Wisconsin, and 21 and 30 years at two locations in northern Iowa, grain yield of first-year corn following alfalfa averaged 8-18% greater than that of continuous corn and 0-8% greater than that of corn following soybean.

Additionally, grain yield of second-year corn following alfalfa averaged 0-8% greater than that of continuous corn, but 2-8% less than that of corn following soybean. Higher yields for first-year corn following alfalfa and sometimes second-year corn following alfalfa in the experiments may have been due to improved soil aggregation and soil infiltration rate, and a reduction in soil compaction, soil- and residue-borne pathogens and insect pests.

Alfalfa typically reduces the nitrogen-application requirement for the two crops of corn that follow it. On medium- and fine-textured soils where alfalfa stands are two years or older when terminated, nitrogen application often does not increase grain yield of first-year corn following alfalfa, and it increases grain yield of second-year corn following alfalfa about half of the time.

But, alfalfa that has been inadequately terminated is highly competitive with young corn plants for water and nutrients. Therefore it’s important for alfalfa to be effectively terminated prior to corn emergence.

For effective termination of alfalfa with herbicide in the fall or spring, alfalfa regrowth should be at least 4-6 inches prior to herbicide application, otherwise there may be poor herbicide translocation to roots. Tillage should typically be delayed until at least three to four days after herbicide application, although some herbicide labels require a longer interval before tillage. Those requirements can cause a delay in corn planting when alfalfa is terminated with herbicide in the spring.

Termination of alfalfa in the fall rather than spring can result in earlier release of nitrogen to the following corn crop, along with earlier drying and warming of soil in the spring. However, termination of alfalfa in the fall results in less cover to protect against soil erosion during the winter if tillage is used.

A highly effective herbicide option for fall termination of alfalfa is 2, 4-D alone or tank-mixed with dicamba. If grasses are present with alfalfa, a good option is to tank-mix glyphosate with 2, 4-D. High rates of glyphosate alone often result in only partial kill of alfalfa — 60-90% kill with fall applications, or 40-80% kill with spring applications.

Tillage implements such as a chisel plow with overlapping sweeps or a moldboard plow, which completely cut off all alfalfa roots, are effective at terminating alfalfa but may not be suitable in some fields due to soil erosion. Tillage implements that do not completely cut off all alfalfa roots will be unable to provide complete alfalfa termination unless herbicide is applied before tillage.

AgUpdate Daily Headlines

* I understand and agree that registration on or use of this site constitutes agreement to its user agreement and privacy policy.

Related to this story

Most Popular

Find the equipment you're looking for

Get up-to-the-minute news sent straight to your device.

Topics

Breaking News