Editor’s note: The following was written by Fabian Fernandez, Extension nitrogen management specialist, and Brad Carlson, Extension educator, for the University of Minnesota Extension website June 3.
Sidedressing nitrogen has become a popular way to apply nitrogen, possibly for a few reasons. Wet springs over the last several years have resulted in N loss from early applications. Sidedressing N allows better distribution of labor and equipment, especially in wet springs when the planting window may be small. Theoretically it makes sense because early spring is when there is greater potential for N loss because of excess precipitation and slow crop uptake. And, because the equipment to sidedress has become increasingly available.
While these may all be good reasons, it is good to re-evaluate management practices periodically.
Split applications don’t always work better than a single pre-plant application close to planting. Over the last several years, we have been doing a substantial amount of research to evaluate sidedress applications and determine where this practice might produce the greatest advantage.
Minnesota participated in a three-year study across eight Midwestern states with a total of 49 sites that encompassed many conditions and situations. We observed that split applications around the V7-V9 development stage produced similar yields to pre-plant applications 82% of the time.
In 14% of sites, the split application was better than the single application. In 4% of the sites, split application was worse than the single application. The sites with a positive response to split-N applications were either coarser textured (sandy) soils or fine-textured soils that experience regular precipitation during sidedress time, which allows the applied N to get to the root-zone. The few sites where the single-N application was better than the split-application were finer-textured soils with high organic matter content.
In a different study over a three-year period with 15 sites in Minnesota, it was observed that when split application improved yield, the best time to make the split application was around the V4 to V8 development stage.
Later application (V12) had no advantage, and even resulted in a yield reduction on some sites compared to the single pre-plant application. This study was funded by Pioneer Hi-Bred (now Corteva), Minnesota’s Agricultural Fertilizer Research and Education Council (AFREC), and the Minnesota Corn Growers Association.
There were two reasons for this reduction. In some cases, yield was lost because the crop was starved for N prior to the application and could not recover. In other cases, where there was little precipitation at the time of sidedress, it is likely that the fertilizer took too long to get into the root-zone.
For the first situation, the solution is to apply higher rates of N with the first split. We observed that if the application is done by V8, 40 pounds N/ac at pre-plant was sufficient (no difference compared to 80 lb N/ac). For the second situation, there is little that can be done, but this is an important point to consider.
Another question to consider is the total rate of N that is needed with a pre-plant vs. a sidedress application. In general, people tend to think that a split application is more efficient. However, we have found that N application timing minimally affects residual soil N content, uptake by corn, and grain yield.
In other words, regardless of when N is applied, the economic optimum N rate is similar if we assume the same cost for fertilization. It is important to recognize that the additional trip across the field for a split application has a cost, which is often not discussed.